Steel wheel weights for wheel and tire balancing is the future. Since the EPA and new automotive manufacturers partnered up to eliminate the use of lead wheel weights, all new vehicle since 2009 have come with steel wheel weights. The EPA launched a campaign to “Get the Lead Out”. The start of this campaign triggered seven states already to outlaw the use of lead wheel weights. Several other states have put this law into legislation. The EPA is also working with the federal government to make this a 50 state law. This law will be passed soon and the rumor of this law being passed is much sooner than later.
Steel is considered a green product. Baron steel adhesive back wheel weights are affordable and recyclable. Our Steel Wheel Weights come in strips of 12 weights and weigh in at .25 ounces or one quarter of one ounce. This is the industry standard for most vehicles on the road. The adhesive tape we use is non resettable. Therefore once applied in the desired position you cannot move it. This insures a perfect bond until your next wheel balancing. (Recommended every 6,000-10,000 Miles)
Baron steel wheel weights have been tested extensively. If the wheel has been properly cleaned and prepped the wheel weights can with stand extremely hot and cold temperatures. Wheel weights that can handle extreme temperatures changes are what every automotive repair shop is looking for. Our steel wheel weights are not only low profile but highly adhesive. Low profile wheel weights increase the chance of the wheel weight NOT falling off at high speeds.
Our wheel weights went through extensive texting for different weather conditions. We used a 96 hour consistent test. During this 96 hour test we did the following tests without failure.
Steel is considered a green product. Baron steel adhesive back wheel weights are affordable and recyclable. Our Steel Wheel Weights come in strips of 12 weights and weigh in at .25 ounces or one quarter of one ounce. This is the industry standard for most vehicles on the road. The adhesive tape we use is non resettable. Therefore once applied in the desired position you cannot move it. This insures a perfect bond until your next wheel balancing. (Recommended every 6,000-10,000 Miles)
Baron steel wheel weights have been tested extensively. If the wheel has been properly cleaned and prepped the wheel weights can with stand extremely hot and cold temperatures. Wheel weights that can handle extreme temperatures changes are what every automotive repair shop is looking for. Our steel wheel weights are not only low profile but highly adhesive. Low profile wheel weights increase the chance of the wheel weight NOT falling off at high speeds.
Our wheel weights went through extensive texting for different weather conditions. We used a 96 hour consistent test. During this 96 hour test we did the following tests without failure.
Adhesive Steel Wheel Weights
Our Non-Lead Steel Adhesive steel wheel weights come in our standard 9 pound box. Each weight is .25 ounces or one quarter of 1 ounce. They come in strips of 12 segments per strip. There are 576 segments per box. This breaks down to .8 cents per weight. These are adhesive wheel weights that bond instantly once....... applied to a clean dry surface. These wheel weights are not repositionable once set.
Adhesive Steel Wheel Weights
Our Non-Lead Steel Adhesive steel wheel weights come in our standard 9 pound box. Each weight is .25 ounces or one quarter of 1 ounce. They come in strips of 12 segments per strip. There are 576 segments per box. This breaks down to .8 cents per weight. These are adhesive wheel weights that bond instantly once....... applied to a clean dry surface. These wheel weights are not repositionable once set.
